Step 3 sand the area.
Patching hardboard siding.
If the nails do not stay put hammer additional 2 inch nails beside the original nail to.
Scrub the brush around the hole to dislodge dirt and debris.
Use a 4 foot level to check and then hammer in another nail.
Sand the area smooth and then paint it to match the rest of the siding.
Slightly overlap the putty onto the surrounding hardboard by 1.
Hammer down loose nails.
How to repair masonite wood siding 1.
After installation you caulk and paint it like any other siding.
Now when somebody googles what i tried they 39 ll at least get my post and know they 39 re not the only one.
Step 2 apply filler compound.
Step 1 check the siding panels and clean the holes.
Level the wood.
Pack wood putty into the hole using a trowel.
Scoop a golf ball sized.
Scrape off flaking paint and debris from the damaged area using a paint scraper.
Then hammer away on the rest of the board.
The wood grain pattern on the fiber cement siding is often a perfect match with existing hardboard although it s not as good a match with real rough sawn wood.
The best filler for your siding is a two part epoxy product that cures to a rock hard consistency.
When the new siding has been painted two coats of top quality acrylic latex over a primer the repair is hard to spot.
If you re replacing more than one board in a run simply hammer a nail into the top corner to support it and then move half way down the board.
Step 4 paint the siding.
Scrub the surface of the rot or.
Check the siding panel for molds holes or any damage.
Be sure the top one goes through both boards.
The siding panels nearest to the.
Immediately fill holes with a flexible all purpose filler such as pre mixed bridging and patching compound following label directions.
So if you re cutting much a masonry blade is a great idea.
If water seeps into joints between hardboard panels or penetrates through small holes it will cause the panels to deteriorate.
How to repair masonite siding with putty step 1.
The fiber cement siding is nailed in place so the rows are consistent with the rest of the wall.
Clean the hardboard with a stiff bristle brush.
1 scrape all loose paint from around the area to be repaired using a paint scraper or putty.
