Pivot the lever up and down 3 times.
Parking brake cable adjuster enabling.
Our parking brake cable shortener is engineered to effectively take up excess slack in cables.
The adjustment bolt will be located on the parking brake lever.
It s constructed from high quality materials for long lasting service.
Two technicians are required to perform this procedure.
Adjust the parking brake.
Brakeware brake cable c11660.
Attempt to rotate the rear tire and wheel assemblies.
Raise and support the vehicle.
Either under the car about midway between the front and the rear or attached to the parking brake lever.
Raise the park brake lever.
Raise and support the vehicle so the tire and wheel assemblies are clear of the ground.
This may cause the emergency brake to not operate.
Apply the electronic parking brake.
One inside the vehicle and one outside the vehicle.
Cycle the park.
Lift the park brake lever boot to gain access to the multiplier lever at the front of the park brake lever assembly.
Get free next day delivery or pick one up in store today.
Check the brake by pulling the lever up and feel for tightness.
Lower the park brake lever.
1 year warranty 22.
Place the transmission in neutral.
Restores tight firm feel when pulling up the emergency brake handle.
Adjusting the parking brake.
Rely on your parking brake again and switch out that brake cable.
Save money by using the cable shortener instead of replacing the entire cable.
If the parking brake feels weak then the parking brake cable may need to have its tension adjusted.
To enable after component replacement to reengage the the automatic adjuster complete the sequence below.
Tighten the bolt by a few turns and then check the parking brake cable.
Disabling the park brake cable automatic adjuster before any components of the parking brake system are serviced the following procedure must be followed.
If your parking brake cable has been damaged o reilly auto parts carries replacement parking brake cables for most vehicles.
The parking brake lever can be foot actuated and mounted to the driver s left or hand actuated and mounted at the driver s right in the center console.
This bolt tightens the cable leading to the rear brakes.
Enable the parking brake cable adjuster.
Except push to release parking brake pedal.
The wheels should not rotate forward.
Park 2 of 3.
