Toolseeker 05 15 2013 05 15 2013 07 52 pm 9.
Painting pressboard siding.
Manufacturers include georgia pacific gp abtico or abitibi price weyerhaeuser and boise cascade.
Pay particular attention to the edges and bottom of each board as these areas tend to absorb water.
Then it s time to go wild and creative by painting the particle board.
Eastern ohio heart of appalachia.
The following user says thank you to kimberland30 for this useful post.
Apply an exterior alkyd primer to the siding using a paint roller.
I am looking to repaint old pressboard siding that is exposed because of flaking.
It s basically particle board siding that is primed and ready for paint.
The best selling brands of pressboard siding include ip s masonite omniwood and lp s inner seal.
Priming and painting apply two coats of a stain blocking primer.
1 watch for any major flaws.
There is no specific kind of paint that you need to use.
Be on the lookout for any cracked paint missing sealant holes loose nails and other such problems in your hardboard siding that could lead to moisture infiltration.
Even slight discoloration can be an indication of water absorbtion.
Let the primer dry completely.
Add an additional coat or two if necessary to thoroughly cover the raw edges of the pressed board.
Use a brush to reach small areas.
As a final bit of preparation sand the primed surface of the chipboard with a 200 220 grit sandpaper to remove imperfections left behind by the primer.
I have cabin fever and i m chomping at the bit to get back outside and resume the exterior painting of my old house.
It is the original paint as far as i can tell.
One of the items on my things to do list is ordering some wood siding.
Is pressure washing still the best way to prep.
There is some swelling but not too bad its only flaking where the sun hits the most not everywhere.
The fiber cement siding is nailed in place so the rows are consistent with the rest of the wall.
The university of wisconsin cooperative extension recommends latex paint when painting wood siding as it is more porous then oil based.
Because cement is the largest component of the siding it s hard on saw blades.
Now underneath this siding we also had to replace the sheathing so we used half inch plywood and a layer of builder s felt.
Painting old pressboard siding.
Brush or roll a thin coat of latex paint onto your siding.
